• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Hi everyone, this is Kaymania again, following on from my intro yesterday, I saw this lathe on ebay.  Is it any good?  it's £78 at the moment and brand new.  Should I be avoiding lathes like this like the plague?!! Or will it do just for pens?  From the tiny bit of info I've gleaned so far, not sure if there's enough room between centres etc?


Thanks for any advice


Top