Dremel Tool Holder.

[Penpal]

This morning I took these pics to show this tool holder to enable the use of a Dremel and various disks ,the one fitted Is A Diamond to cut some real tough stuff. The Dremel is just sitting in the holder not firmed up it mounts on dead centre. I cut grooves for spring clips,cut brass tubes etc value it highly. The Aluminium extrusion is the perfect size came from a truck body builder in Canberra who uses it for holding big swivel pins that swing the rear gate on trucks.It could just as easy been made to fit a tool post on a wood lathe.

Peter.

 

[fortress]

That’s a good idea Peter, very practical.

 

[Bill Mooney]

I like that Peter. A good idea which should work really well.

 

[Vic Perrin]

Novel idea Peter. I need to see more posts like these relating to metal lathes. My Atlas installation is nearly complete just got the cross shaft and motor to install and then it's playtime

 

[wm460]

 

[yorkshireman]

You give some great hints and tips Peter mate

 

[Phil Dart]

Neat solution Peter

 

[Dalboy]

Great idea Peter.

 

[21William]

Nice addition to the Lathe Peter. Not sure if you can still get them but they used to make tool post grinders years ago.

 

[Penpal]

Check out tool post grinders on U Tube.

Peter.