• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

I sharpen by hand on a strip sander. I pay very close attention to the cutting edge to keep the angles the same for about 1/16 inch.  After that I can be a little less attentive.  Go slow and remove matl from both flutes as equally as possible.


Top