New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Update I have been messing with the diferent sets of chuck jaws to see what the difference is. I have come to the conclusion that if I pop the Axminster lathe jaws on my Milling machine I can modify them to fit on my metal lathe this then gives me the option to use any of the Chuck fittings on the metal lathe. An interesting project that will keep me out of michief for the week end. But un likely I will use anything other than the pen jaws on the meatal lathe. Of course if it works and some one else has a metal lathe they would like to mount pen jaws on ???

[QUOTE="alpha1, post: 362653, member: 1847"] Update I have been messing with the diferent sets of chuck jaws to see what the difference is. I have come to the conclusion that if I pop the Axminster lathe jaws on my Milling machine I can modify them to fit on my metal lathe this then gives me the option to use any of the Chuck fittings on the metal lathe. An interesting project that will keep me out of michief for the week end. But un likely I will use anything other than the pen jaws on the meatal lathe. Of course if it works and some one else has a metal lathe they would like to mount pen jaws on ??? [/QUOTE]

Verification