• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Whatever drill you use, drill slowly.  I drill a 7mm hole then work up a few mm at a time until I get the size I need.  The acrylic may soften and bind so its also important to keep removing the drill to clear the excess.  Good Luck :thumbs:


Top