New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

thanks guys.. I have done the kiss test and running true. . This was the first thing I did when I set up the lathe as I have researched for weeks to make sure I at least have the first clue about getting set up right.. I have now more ideas about where I am going wrong. I did search but obviously didn't use quite the search terms. But thanks for the advice and sorry for opening the can of worms.... on the positive side. .. we must have enough worms for a good fishing trip.. [emoji12]

[QUOTE="Baldy, post: 86415, member: 478"] thanks guys.. I have done the kiss test and running true. . This was the first thing I did when I set up the lathe as I have researched for weeks to make sure I at least have the first clue about getting set up right.. I have now more ideas about where I am going wrong. I did search but obviously didn't use quite the search terms. But thanks for the advice and sorry for opening the can of worms.... on the positive side. .. we must have enough worms for a good fishing trip.. [emoji12] [/QUOTE]

Verification