• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Get a letter O bit and run it through the Norseman hole or just drill with the O bit. It is .001" bigger than the 8mm bit. I that doesn't work look for an 8.1 or 8.2 mm bit at one of the machining tool suppliers in Vancouver. KBC for example.


Pete


Top