• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Hi Neil I use Jobber bits and slow and clearing drill bit along the way one reason is if you use corian over 1/2" it will be glued and any heat build up will break the join but is saying that I think some manufacturers are now making it up up 20mm thick


Top