• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

I'd advise always drill smaller holes and work your way up, unless it's a 7mm hole. Say your want a 10.5mm hole, start with a 7mm drill bit (or even a 5mm), then an 8mm one and finally the 10.5mm :thumbs:


Top