Epsilon assembly

[rayf6604]

I've just had my first batch of Epsilon kits from Dan and its taken me a while to figure out how it assembles. I think I've got it now but just to make sure is this right?

The small brass piece at nib is pushed in to one end of the tube and nib screwed into it. The larger brass piece goes in the other end with the clip under the wider section. The fancy band is pushed on over the brass part with the mechanism screwed inside and the twist top I'd then pushed on over the mechanism?

 

[Phil Dart]

That's exactly right Ray.

 

[Woody]

Have a look on Dans web site he must have the instructions on there but what you have done looks right to me

 

[paulm]

That looks about right to me Ray. Beware that one of the bushes is smaller than the other and its not that obvious. The smaller end is the nib end.

 

[wm460]

You got the bit in the middle missing, commonly called a blank.:wink:

 

[donwatson]

You got the bit in the middle missing, commonly called a blank.:wink:

Otherwise it looks good for me. I haven't made any of these yet so I don't really know

 

[rayf6604]

That looks about right to me Ray. Beware that one of the bushes is smaller than the other and its not that obvious. The smaller end is the nib end.

Do you know I thought that the nib end looked smaller but I wasn't convinced. I'll get my vernier calipers onto them to make sure. Many thanks to you all for your help and assurance.

 

[Penpal]

Deed done now the blank and the pen.

Peter.

 

[rayf6604]

Deed done now the blank and the pen.

Peter.

They're on the way, just waiting for the glue to dry and another day off, Sat looks favourable