New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Executive Ball point dressed in spalted beech with a CA finished,
The Executive Ball point plating is up to TMs quality the build is sold if a little tight when pressing together weights 62gs ,
But the thread on end cap is longer than the inner when pressed together it crunches the end of the blank the OD of inner cap
is the same size as the brass tube so when fitting the end cap take the cover off before pressing together
then fit the cover hope this helps now to knock the end off I hope :pray:

[QUOTE="Barry, post: 218463, member: 713"] Executive Ball point dressed in spalted beech with a CA finished, The Executive Ball point plating is up to TMs quality the build is sold if a little tight when pressing together weights 62gs , But the thread on end cap is longer than the inner when pressed together it crunches the end of the blank the OD of inner cap is the same size as the brass tube so when fitting the end cap take the cover off before pressing together then fit the cover hope this helps now to knock the end off I hope :pray: [/QUOTE]

Verification