New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

So I am glad to see the back of these...a lot of batch work, drilled the heads on the lathe in a collet chuck, fitted to the cases with a lee reloading press and die, then drilled 1/4" hole for the transmission....there are 20 done, but I didn't realise one had rolled off the table till later

[QUOTE="flexi, post: 373926, member: 626"] So I am glad to see the back of these...a lot of batch work, drilled the heads on the lathe in a collet chuck, fitted to the cases with a lee reloading press and die, then drilled 1/4" hole for the transmission....there are 20 done, but I didn't realise one had rolled off the table till later [/QUOTE]

Verification