New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I am using a polyurethane titebond glue. I used a old drill bit just a fraction smaller diameter than the tube and pushed it through as the glue was going off to get rid of any excess in the tube. I will make sure the next one I do I rough the tube up so the glue makes a better contact thanks for the advice .

[QUOTE="mattkemp, post: 238474, member: 1353"] I am using a polyurethane titebond glue. I used a old drill bit just a fraction smaller diameter than the tube and pushed it through as the glue was going off to get rid of any excess in the tube. I will make sure the next one I do I rough the tube up so the glue makes a better contact thanks for the advice :thumbs:. [/QUOTE]

Verification