New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Very good, Mark!!! I like that you had all the processes in place to make the pen. There ain't no stopping you now!
PS. It may already be mentioned but that break-out you had might be caused by not making sure that the CA was spread evenly along the tube - if its "floating" there will be no support against the chisel, and the loose bit will fly off! But you knew that already, right?

Bob.

[QUOTE="bluntchisel, post: 140842, member: 249"] Very good, Mark!!! I like that you had all the processes in place to make the pen. There ain't no stopping you now! PS. It may already be mentioned but that break-out you had might be caused by not making sure that the CA was spread evenly along the tube - if its "floating" there will be no support against the chisel, and the loose bit will fly off! But you knew that already, right? Bob. [/QUOTE]

Verification