New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

If it’s a solid wall- chemical wall plugs are great . Drill hole into wall set a length of threaded stainless steel into the wall by placing chemical plug in hole then knocking threaded rod into it . Allow to cure then use the sticking out bit of threaded rod to mark edge of shelf , drill hole (over deep ) into shelf and a small hole underneath to intersect and to let you tighten a nut drawing shelf to the wall. If it bothers you plug the hole under the shelf afterwards .

[QUOTE="howsitwork?, post: 372870, member: 2121"] If it’s a solid wall- chemical wall plugs are great . Drill hole into wall set a length of threaded stainless steel into the wall by placing chemical plug in hole then knocking threaded rod into it . Allow to cure then use the sticking out bit of threaded rod to mark edge of shelf , drill hole (over deep ) into shelf and a small hole underneath to intersect and to let you tighten a nut drawing shelf to the wall. If it bothers you plug the hole under the shelf afterwards . [/QUOTE]

Verification