New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

[ATTACH]10482[/ATTACH]Beech and walnut no sanding use the cut of the blade as the key[ATTACH]10480[/ATTACH]
double side tape them together run through the bandsawThen glue[ATTACH]10481[/ATTACH]
top pic is the glued blank turned to round design is only limited
by the number of cuts before turning but cut 2 blanks at once
always i find it makes the cut a better fit thoughts..

[QUOTE="turnaround360, post: 104423, member: 69"] [ATTACH]10482._xfImport[/ATTACH]Beech and walnut no sanding use the cut of the blade as the key[ATTACH]10480._xfImport[/ATTACH] double side tape them together run through the bandsawThen glue[ATTACH]10481._xfImport[/ATTACH] top pic is the glued blank turned to round design is only limited by the number of cuts before turning but cut 2 blanks at once always i find it makes the cut a better fit thoughts.. [/QUOTE]

Verification