• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Interesting one. Why this came to mind is I was reading on Timberbits site and David said he left his overnight and he uses CA and I couldn't understand why??

Now I know that I am not alone in leaving them for a short time.

I would be like some of you in doing it immediately but after drilling on the lathe I then put my sanding disc on and I usually do this while the CA is going off!!!:thumbs:


Top