New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Neil,Yes I used the correct bits 31 and 33 64ths I drilled them yesterday and had them in the house overnight for gluing the tubes were quite neat in the hole so mabye the holes closed in a bit.This is only the 2nd time I have used CA as I normally use epoxy,only thought Id try the CA as tubes were tight.

[QUOTE="Themackay, post: 123183, member: 430"] Neil,Yes I used the correct bits 31 and 33 64ths I drilled them yesterday and had them in the house overnight for gluing the tubes were quite neat in the hole so mabye the holes closed in a bit.This is only the 2nd time I have used CA as I normally use epoxy,only thought Id try the CA as tubes were tight. [/QUOTE]

Verification