waterbuffalo
Full Member
something ive never tried before....can anyone tell me the best glue for corian please
-
Thanks for visiting The Penturners Forum today.
There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.
To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.
going to attempt
- Thread starter waterbuffalo
- Start date
I use epoxy 2 part for Corian. Used to use CA and polyurethane gorilla glue. So know all those work
waterbuffalo
Full Member
Penpal
Grand Master
I used to drill etc up to a hundred at a time and have used many glue types successfully,I choose Gorrilla brown normally.
i will, and thank you again Woody
Just make sure you have your components lined up straight and your tubes are cleaned up when assembling or the corian will crack open good luck and enjoy
Penpal
Grand Master
When Corian was a new product over here in Aus the dealers we terribly secretive,now a daysthicker than 1/2 inch thick abounds ,much easier than drilling 7mm holes in 1/2 inch square blanks IMHO.
