• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

I believe Tormek were aware of the shortcomings of their system for anything other than final sharpening. This may be why they started selling Tormek compatible supports for standard bench grinders. Do all the rough work and re-profiling etc on a bench grinder then finish it off on the Tormek?


Possibly the best setup for the Tormek is to use their Diamond wheels but they aren’t cheap!


Top