New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Another first for me - I used some deep pour resin on pine cones. The type used is not supposed to require a pressure pot or anything external, just mixing and pour leave 5-7 days.
Well there were more bubbles than I care to admit and turning it was....challenging for my ability.

I thought about not posting, and at one point thought I'd have nothing to post anyway!

Still I have managed to produce something, nowhere as thin as I'd like or the shape I wanted, or the finish I wanted but it is something so I'm happy but not happy!

Here ya go:

[ATTACH]45848[/ATTACH][ATTACH]45849[/ATTACH][ATTACH]45850[/ATTACH]

Regards

Padster

[QUOTE="Padster, post: 356066, member: 2376"] Another first for me - I used some deep pour resin on pine cones. The type used is not supposed to require a pressure pot or anything external, just mixing and pour leave 5-7 days. Well there were more bubbles than I care to admit and turning it was....challenging for my ability. I thought about not posting, and at one point thought I'd have nothing to post anyway! Still I have managed to produce something, nowhere as thin as I'd like or the shape I wanted, or the finish I wanted but it is something so I'm happy but not happy! Here ya go: [ATTACH]45848._xfImport[/ATTACH][ATTACH]45849._xfImport[/ATTACH][ATTACH]45850._xfImport[/ATTACH] Regards Padster [/QUOTE]

Verification