New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Welcome Paul.

I too have a Chinese lathe (seig) and it’s fantastic for the money. It took a little time to get it set up accurately, and I view it as an ongoing project in itself (I’ve made parts for it to create improvements over time).

Anyway good luck with the hobby.

Cheers
Ash

[QUOTE="ValleyBoy, post: 372261, member: 2096"] Welcome Paul. I too have a Chinese lathe (seig) and it’s fantastic for the money. It took a little time to get it set up accurately, and I view it as an ongoing project in itself (I’ve made parts for it to create improvements over time). Anyway good luck with the hobby. Cheers Ash [/QUOTE]

Verification