• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Help needed Can anyone make me a handle for my carbide insert?

S

Skin-Job

Full Member
Joined
Oct 6, 2017
Posts
172
Location
London, England
First Name
Karl
I found a really interesting carbide insert here:

CTD-L Carbide Teardrop Cutter, 1 3/4" x 3/4 x 1/8" - AZ Carbide

I bought one, and now need a square shaft and handle to mount it on for use.
It would need to be flat to the square section shaft, but inset so the cutting edge is level with the top of the square section of the shaft.
It would also need to allow for rotation of the insert to move any of the cutting edges to the front.

Can anyone here do this for me? Happy to pay the going rate.

karl@skin-job.com

Many thanks,

Karl
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top