New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Good point Bill, I had muchly problems with my Charnwood lathe when I first received it.
It was only when I rebuilt it from putting the new bearings in that I found the swivel locating plate was assembled incorrectly and the pin was just a gnats cock out of alignment.
Perfick now init?

[QUOTE="Grump, post: 219283, member: 232"] Good point Bill, I had muchly problems with my Charnwood lathe when I first received it. It was only when I rebuilt it from putting the new bearings in that I found the swivel locating plate was assembled incorrectly and the pin was just a gnats cock out of alignment. Perfick now init? [/QUOTE]

Verification