New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I think that my post was misleading where I stated "try to go from left to right as much as you can". I still would cut from left to right as much as I could in this case but as Walter stated don't start off of the blank and come into the end always cut so you come off of the end. Thank you Walter for your post which brought my attention to how I explained this wrong. Never was much good at putting things into the written word

[QUOTE="Dalboy, post: 279622, member: 449"] I think that my post was misleading where I stated "try to go from left to right as much as you can". I still would cut from left to right as much as I could in this case but as Walter stated don't start off of the blank and come into the end always cut so you come off of the end. Thank you Walter for your post which brought my attention to how I explained this wrong. Never was much good at putting things into the written word [/QUOTE]

Verification