• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Welcome Jim. Sorry I can't help you with advice on what's available. I use an Elliott unimat lathe which I've had since 1972 & is still going strong. It is great for small jobs as it converts into a pillar drill & milling table. It has speeds from approx 200 - 6000 rpm.


Top