New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

John, I just remembered in your introduction you mentioned you had a Boxford Lathe my memory also is they are related to our Hercus Lathe so I enclose a pic of my Hercus are they alike in any way? Also thanks for your pm when the shouting and must be attended to is under control here I will follow through with my offer of info etc.

Kind regards Peter. PS Parts removed during a clean up of my lathe made in 1967 in other words on other days covered in swarf etc.

[QUOTE="Penpal, post: 15915, member: 122"] John, I just remembered in your introduction you mentioned you had a Boxford Lathe my memory also is they are related to our Hercus Lathe so I enclose a pic of my Hercus are they alike in any way? Also thanks for your pm when the shouting and must be attended to is under control here I will follow through with my offer of info etc. Kind regards Peter. PS Parts removed during a clean up of my lathe made in 1967 in other words on other days covered in swarf etc. [/QUOTE]

Verification