• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Hi folks

Garno

Garno

Fellow
Joined
May 12, 2021
Posts
1,372
Location
Dronfield
First Name
Gary
Hi everyone,

Just passing by and thought I would pop in and say hello to you all.

I have missed posting on here but as I no longer make pens there was nothing I could add, until today that is,
This popped up on my YouTube recommends, no idea why, but it was an enjoyable video to watch.
Have a gander

https://www.youtube.com/watch?v=j27RKTHMLkA

Be good :tongue::tongue::tongue:
 
Dalboy

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,708
Location
Kent
First Name
Derek
Have watched nearly all of this guys videos and find them very clear with no nonsense.

Some may notice the use of American thread sizes especially where he attaches the clip. He used 2-56 which for those that don't know is equivalent to 8BA or 2.5mmwhich is 0.086". The nearest imperial is 3/32 or 0.098.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top