home made pen mould

[turnaround360]

I had a go at making some moulds
on the hole they are ok but the lugs are a bit big and will need triming but its a start Frankie

 

[Buckeye]

Don't trim the lugs until you have tried them, you need to have a good seal.

Peter

 

[rowdyyates115]

Well done Frankie..... looking good.
What resin you planning using in these moulds?

 

[turnaround360]

Don't trim the lugs until you have tried them, you need to have a good seal.

Peter

they are to fat for the tubes I just need to thin them slightly,
Rowdy clear cast resin got a couple of ideas I want to try Frankie.

 

[Jim]

Good effort Frankie, look forward to prototype two ...

 

[Buckeye]

they are to fat for the tubes I just need to thin them slightly,

Did you not use tubes in the former?

Peter

 

[Jimjam66]

Looks good Frankie! Waiting with keen anticipation for the casts ...

 

[turnaround360]

No it was holes drilled to form the plug silicone
fills the hole when you remove the former the grommit is left

 

[Grump]

they are to fat for the tubes I just need to thin them slightly,

Kindly moderate your language please young man, I resemble that remark init?

 

[bluntchisel]

Nice work, Frankie - your project looks to be near completion!

Bob.

 

[turnaround360]

Bob it's a never ending quest this pen lark lol..
Frankie.

 

[bluntchisel]

LOL, Frankie, but you are taking it to another level, which is a good thing, matey!

Bob.