New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I want to try CA finishes, but was afraid of the bushings getting glued to the blank. So I decided to make some Delrin bushings. I got a piece of 1/2" Delrin rod from my local plastics supplier. Mounting pieces of the rod in a chuck, I drilled them through with a letter D drill bit. Then cut a taper with a skew, and cut them off. I think they're going to work well.

[QUOTE="qquake2k, post: 209720, member: 1150"] [SIZE=3]I want to try CA finishes, but was afraid of the bushings getting glued to the blank. So I decided to make some Delrin bushings. I got a piece of 1/2" Delrin rod from my local plastics supplier. Mounting pieces of the rod in a chuck, I drilled them through with a letter D drill bit. Then cut a taper with a skew, and cut them off. I think they're going to work well.[/SIZE] [/QUOTE]

Verification