• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Tried this today...drilled a blank of oak, cut them at 4mm on the bandsaw,then faced the oak blank using a Transfer punch on my lathe and repeated.


Will post results tommorow :bwink:


Top