• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

300rpm is good with a jobber Neil, if the drill gets to warm you will get that gunge that goes hard very quickly, Colt bits are superb for this material as they go through it like butter...


As for finishing i just use the Micro-Mesh sanding pads and polish with Meguiars Scratch X, or Hut plastic polish ... 


Those pens do look good indeed ... :bwink:


Top