• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Re-watched the video & I was right re the colt being designed for end grain.




Yep, years ago I used to rout quite a bit of Perspex, I ended up buying a variable speed router so I could cut at a low speed as any build up of heat caused problems.


Top