New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Not posted much as I try to keep this thread to a minimum but I like to add the odd bit to show I am still doing something in the workshop. I did check my wood store for a piece of wood for another turning project.

Anyway since the last update I have made the cylinder liner and some of the machining to the piston. I am now working on the head assembly the size can be seen where I am holding the head.

[ATTACH]50216[/ATTACH][ATTACH]50217[/ATTACH]

Most of the holes are drilled in the head and the valve guides made and inserted these needed to be fitted before some more holes are drilled as well as act as guides for another hole.

[ATTACH]50218[/ATTACH]

[ATTACH]50219[/ATTACH][ATTACH]50220[/ATTACH][ATTACH]50221[/ATTACH]

Just a quick couple of photo with the valves inserted

[ATTACH]50222[/ATTACH][ATTACH]50223[/ATTACH]

<blockquote data-quote="Dalboy" data-source="post: 364517" data-attributes="member: 449">Not posted much as I try to keep this thread to a minimum but I like to add the odd bit to show I am still doing something in the workshop. I did check my wood store for a piece of wood for another turning project.Anyway since the last update I have made the cylinder liner and some of the machining to the piston. I am now working on the head assembly the size can be seen where I am holding the head.[ATTACH]50216[/ATTACH][ATTACH]50217[/ATTACH]Most of the holes are drilled in the head and the valve guides made and inserted these needed to be fitted before some more holes are drilled as well as act as guides for another hole.[ATTACH]50218[/ATTACH][ATTACH]50219[/ATTACH][ATTACH]50220[/ATTACH][ATTACH]50221[/ATTACH]Just a quick couple of photo with the valves inserted[ATTACH]50222[/ATTACH][ATTACH]50223[/ATTACH]</blockquote>

[QUOTE="Dalboy, post: 364517, member: 449"] Not posted much as I try to keep this thread to a minimum but I like to add the odd bit to show I am still doing something in the workshop. I did check my wood store for a piece of wood for another turning project. Anyway since the last update I have made the cylinder liner and some of the machining to the piston. I am now working on the head assembly the size can be seen where I am holding the head. [ATTACH]50216[/ATTACH][ATTACH]50217[/ATTACH] Most of the holes are drilled in the head and the valve guides made and inserted these needed to be fitted before some more holes are drilled as well as act as guides for another hole. [ATTACH]50218[/ATTACH] [ATTACH width="270px"]50219[/ATTACH][ATTACH]50220[/ATTACH][ATTACH]50221[/ATTACH] Just a quick couple of photo with the valves inserted [ATTACH]50222[/ATTACH][ATTACH]50223[/ATTACH] [/QUOTE]

Verification