New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

The governor parts pile has some more parts added to it all small parts but seem to take ages to do even if they are simple still some more to make. I have not yet soldered any parts as there are a few more that need hardening so will do the soldering and hardening all at the same time weather permitting as it is raining here.
The brass pins with the thread on the left are 1/8" diameter to give an indication of size the split pins that will be used on the silver steel pins are 1/32" to fit in the tiny holes

[QUOTE="Dalboy, post: 366614, member: 449"] The governor parts pile has some more parts added to it all small parts but seem to take ages to do even if they are simple still some more to make. I have not yet soldered any parts as there are a few more that need hardening so will do the soldering and hardening all at the same time weather permitting as it is raining here. The brass pins with the thread on the left are 1/8" diameter to give an indication of size the split pins that will be used on the silver steel pins are 1/32" to fit in the tiny holes [/QUOTE]

Verification