New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Not done much but have now managed to complete the fuel mixer after having problems drilling a small #76 drilled hole through a 2/8" rod which can be seen in the second photo. The last one is of the assembled fuel. The main body is from 1/2" hexagonal bar. I also need to replace the grub screw as it is a little too long.
[ATTACH]51815[/ATTACH][ATTACH]51816[/ATTACH][ATTACH]51817[/ATTACH]

[QUOTE="Dalboy, post: 368787, member: 449"] Not done much but have now managed to complete the fuel mixer after having problems drilling a small #76 drilled hole through a 2/8" rod which can be seen in the second photo. The last one is of the assembled fuel. The main body is from 1/2" hexagonal bar. I also need to replace the grub screw as it is a little too long. [ATTACH alt="fuel mixer #2 (1).jpg"]51815[/ATTACH][ATTACH alt="fuel mixer #2 (2).jpg"]51816[/ATTACH][ATTACH alt="fuel mixer #2 (6).jpg"]51817[/ATTACH] [/QUOTE]

Verification