New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Back onto the Farm Boy with the beginning of turning the flywheels, these were done on a faceplate. Only one side on both of them the outer diameter is just a little over the final size so that once fully machining of the centre and the sides I will take the diameter to final size mounting it on an Arbor.

[QUOTE="Dalboy, post: 370524, member: 449"] Back onto the Farm Boy with the beginning of turning the flywheels, these were done on a faceplate. Only one side on both of them the outer diameter is just a little over the final size so that once fully machining of the centre and the sides I will take the diameter to final size mounting it on an Arbor. [/QUOTE]

Verification