New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Thank you Bill.

I have managed to start on the second side of the fly wheels, bringing the diameter to 6" and cleaning the sides. I have started to bring the centre boss down to size as can be seen in the photos. The flywheels are cast iron and certainly make a mes when turning my hands were black just doing these few operations as it gets everywhere

[ATTACH]52314[/ATTACH]

[ATTACH]52313[/ATTACH]

[ATTACH]52315[/ATTACH]

[QUOTE="Dalboy, post: 370558, member: 449"] Thank you Bill. I have managed to start on the second side of the fly wheels, bringing the diameter to 6" and cleaning the sides. I have started to bring the centre boss down to size as can be seen in the photos. The flywheels are cast iron and certainly make a mes when turning my hands were black just doing these few operations as it gets everywhere [ATTACH]52314[/ATTACH] [ATTACH]52313[/ATTACH] [ATTACH]52315[/ATTACH] [/QUOTE]

Verification