New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I have now sorted out the centre boss and extended one side as they are a little short.

I have now completed the main turning on these, with only the tapered turning on one side of each to do, and the holes drilled for the fixing flange to attach.
I also managed to form the keyway on both, which I was nervous about as the broach is only 1/8" wide, but it went a lot easier than I expected.

[ATTACH]52377[/ATTACH]

[ATTACH]52378[/ATTACH]

[QUOTE="Dalboy, post: 370829, member: 449"] I have now sorted out the centre boss and extended one side as they are a little short. I have now completed the main turning on these, with only the tapered turning on one side of each to do, and the holes drilled for the fixing flange to attach. I also managed to form the keyway on both, which I was nervous about as the broach is only 1/8" wide, but it went a lot easier than I expected. [ATTACH]52377[/ATTACH] [ATTACH]52378[/ATTACH] [/QUOTE]

Verification