• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

If I thought I was back on track with my last post, it has only taken me since then to drill and tap 6 small holes. This was due to me going down with a severe chest infection and not fit to play with machines.

Hopefully (touch wood) I am now back on track.

Fly wheel drilled and tapped

Fly wheel drilled and tapped 1

So nearly finished the flywheels, just need to put a taper in the centre hole which will become clearer in the operation after that


Top