Not been in the workshop much as sorting out my rear lights on the car as a Morrisons van decided to back into it outside the house.
[ATTACH=full]52930[/ATTACH]
More work on the Fuel tank. First a little late I managed to get both stand uprights completed, all except the fixing holes. As well as the end cap fixing screws.
Onto the tank once again drilled the filler hole and fuel outlet, this was threaded 1/4″ x40. Turned some brass for the outlet elbow and did the same method as I did for the carburettor elbow by milling at 45deg most of the way through heating and bending before silvers soldering.
Twisted the tank upside down to show the outlet pipe in position. I need to take apart to clean swarf out of the inside
