New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I was doing so well turning Rhino blanks... Got the lower body of this one turned and polished. Then as I was turning the upper body, this happened. I was so close, too. I hoped it would wet sand out, but it was too deep. I decided to try to fix it with thick CA. Don't know if it will work, but I'll find out tomorrow.

[QUOTE="qquake2k, post: 234840, member: 1150"] [SIZE=3]I was doing so well turning Rhino blanks... Got the lower body of this one turned and polished. Then as I was turning the upper body, this happened. I was so close, too. I hoped it would wet sand out, but it was too deep. I decided to try to fix it with thick CA. Don't know if it will work, but I'll find out tomorrow.[/SIZE] [/QUOTE]

Verification