New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I use all forms of measurement metric fraction imperial and decimal imperial, the last as I measure in 1,000th of an inch. Drill bits in metric can be brought in 0.01mm increments.
I use imperial, metric, number and letter drill bits the first two I have two sets of each the second set are ground for drilling materials like brass which would normally snatch when using standard 118deg grind

[QUOTE="Dalboy, post: 360561, member: 449"] I use all forms of measurement metric fraction imperial and decimal imperial, the last as I measure in 1,000th of an inch. Drill bits in metric can be brought in 0.01mm increments. I use imperial, metric, number and letter drill bits the first two I have two sets of each the second set are ground for drilling materials like brass which would normally snatch when using standard 118deg grind [/QUOTE]

Verification