New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

The problem with the table saw when cutting small triangles is that it chews one of the edges. I adapted a jig that i saw on youtube for the bandsaw. I have been trying to adapt it for the scrollsaw without much success, but still trying. Here's a photograph. The jug is static and the material is pushed along the groove.[ATTACH]53080[/ATTACH][ATTACH]53081[/ATTACH]

[QUOTE="alan morrison, post: 373032, member: 2049"] The problem with the table saw when cutting small triangles is that it chews one of the edges. I adapted a jig that i saw on youtube for the bandsaw. I have been trying to adapt it for the scrollsaw without much success, but still trying. Here's a photograph. The jug is static and the material is pushed along the groove.[ATTACH]53080[/ATTACH][ATTACH]53081[/ATTACH] [/QUOTE]

Verification