• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

I had this problem two months ago it blew my control box replaced the control box still did not work the cause was that the brushes in the motor were worn

replaced the brushes now works fine my lathe is a Charnwood


Top