• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Jigs for turning

Dalboy

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,708
Location
Kent
First Name
Derek
I am starting another turning project and realised that I need some way of holding a sphere so that I can hollow them. If the wood was large enough I could have hollowed after turning the outside.
Anyway around the problem is a doughnut jig, while I am at it some kind gentleman from another forum made me a couple of bits for another project so I completed that one as well.
The small doughnut jig. And the earing hole jig
 

Attachments

  • DSCF1564 (1024x761).jpg
    DSCF1564 (1024x761).jpg
    66.7 KB · Views: 50
  • DSCF1565 (1024x768).jpg
    DSCF1565 (1024x768).jpg
    65.7 KB · Views: 52
  • DSCF1567 (1024x768).jpg
    DSCF1567 (1024x768).jpg
    67.5 KB · Views: 52
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top