• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

I may even start to turn another pen so in preparation I brought a small press to add to the workshop. The steel rule is 12" and the rate for this little tool is 3 ton, do you think it would work :devil:  :funny:  :funny:  :funny:


Top