New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Many thanks for all of the kind comments. I'd been doing so much turning I fancied a break and going back to 'woodwork'. I made myself a router table and then bought a fantastic piece of kit that I did the joints with. It's a Leigh RTJ400 router table jig and I got it through Axminster. It really is good and easy to use. The router bit sticks out of the table and you move the jig over it rather than having the jig held down on the table. Can't recommend it highly enough. As for the felt, it is 1mm thick black felt bought from Amazon. No adhesive on the back but my other half Penny got to work with pva and stuck it over the routed grooves. She is actually quite a woodworker herself and these are two of her latest pieces on the scrollsaw[ATTACH]21509[/ATTACH][ATTACH]21510[/ATTACH]

[QUOTE="paulloseby, post: 209095, member: 565"] Many thanks for all of the kind comments. I'd been doing so much turning I fancied a break and going back to 'woodwork'. I made myself a router table and then bought a fantastic piece of kit that I did the joints with. It's a Leigh RTJ400 router table jig and I got it through Axminster. It really is good and easy to use. The router bit sticks out of the table and you move the jig over it rather than having the jig held down on the table. Can't recommend it highly enough. As for the felt, it is 1mm thick black felt bought from Amazon. No adhesive on the back but my other half Penny got to work with pva and stuck it over the routed grooves. She is actually quite a woodworker herself and these are two of her latest pieces on the scrollsaw[ATTACH]21509._xfImport[/ATTACH][ATTACH]21510._xfImport[/ATTACH] [/QUOTE]

Verification