• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Lignum vitae Mistrals

R

Ratty

Full Member
Joined
May 14, 2016
Posts
192
Location
Ivybridge
First Name
David
Well this commission for rollerballs and fountain pens was a real test, the wood was only just thick enough to use.
Very little room for error in drilling or finishing. It was only 14.5mm thick and that was the thicker pieces.
Lovely to turn and finish though even after being wrapped around a boats prop shaft for the best part of 100 years.
A very rewarding job to get finished and shipped.
 

Attachments

  • 20211130_153950.jpg
    20211130_153950.jpg
    61.6 KB · Views: 35
flexi

flexi

Executive Member
Joined
Sep 12, 2014
Posts
6,454
Location
Maidstone
First Name
mark
Sooner you than me with that drilling!!
Well done, I hope the client appreciated the skills:thumbs::thumbs:
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top