• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

All I do Steven is glue it up in the herringbone pattern then I put it on the belt sander to square it up them cut of both ends and stick a bit on each end then drill and sand save the bits from the internal V end to start the next one


Top